![]() ![]() Setting the wheel circumference The figures 2155, standard wheel circumference for 27", will flicker as shown in fig. ![]() Or, the "Selecting Values Cross Reference Table" tells you an approximate circumference according to tire size. Mark the start and the end of the revolution on the ground and then measure the distance between the two marks. How to measure the wheel circumference(Fig.4) Put a mark on the tire tread and ride the bike one full wheel revolution. Since all the memories are erased, set the main unit again according to "Main Unit Preparation" MAIN UNIT PREPARATION This operation should be executed only when irregular dis- play occurs or no display appears. All displays illuminates, then the mile/h symbol alone ap- pears. (When the two buttons are pressed in O mode, the wheel circumference stored will be displayed.) ○ ALL CLEAR: When the AC button is pressed, all data stored in memory (trip dis- tance, speed scale, wheel circumference and clock time) will be erased. The memorized Trip Distance, Elapsed Time, Average Speed and Maximum Speed will be erased. on/off the Automatic Start/Stop ○ RESET: Select any mode except Total Distance (O), and press the Mode button and Start/Stop button simultaneously. Set Button (middle button) When the Set Button is pressed in the stop state in each mode, the following value can be changed.Pressing the mode button can shift the main display from Current Speed to Cadence when Auto Mode is functioning. During operation the speed scale symbol flickers. Start/Stop Button (right button) Measuring of the Trip Distance and Elapsed Time is simultaneously started or stopped when the Start/Stop button is pressed.If the mode button is held for over 2 seconds, 24-hour clock will be displayed. Mode Button (left button) The display mode mark shift in the illustrated sequence each time the button is pressed, and the corresponding data is simultaneously displayed on the sub-display.Do not apply paint thinner, benzine or alcohol, to avoid damages on the surface. For cleaning, use neutral detergent on soft cloth, and wipe off later with dry cloth.If mud, sand or the alike clogs between the buttons and the body, the movement of the buttons may be disturbed.Check relative position of sensor and magnet periodically.Do not pay too much attention to your computer's functions while riding! Keep your eyes on the road and duly consider to traffic safety.Do not disas- semble the main unit, sensor and magnet. Do not leave the main unit exposed to direct sunlight when the unit is not in use.L CR2032 CC-CD100N II MAINTENANCE/PRECAUTIONS ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |